3.
Press and hold the PTT button. The radio will display
and a short beep sounds (if programmed) indi-
cating that communication can begin.
4.
Hold the radio approximately three inches from the
mouth and speak in a normal voice into the micro-
phone (located at upper left front corner).
5.
Release the PTT button when the transmission is
complete and listen for a reply.
The following procedures outline scan operations for
conventional channels.
Adding Channels To A Scan List
1.
With scan operation turned off select the desired
channel to add to the selected conventional system
channel scan list.
2.
Press
A
(Scan) or
6
(System). The current
status will be displayed in column 1 of line one for a
time-out period. Press
A
or
6
to add the
channel to the scan list. S is displayed on the line.
This sets the selected channel for non-priority scan-
ning. A second press of
A
or
6
sets the chan-
nel for priority-two scanning and 2 is displayed on
line one. An additional press of
A
or
6
sets
the channel for priority-one scanning and 1 is dis-
played on line one. If the priority-one or priority-two
channels are already set and a new channel is then
assigned as the priority-one or priority-two channel,
the previously assigned priority channel will change
84
Summary of Contents for EDACS PRISM HP
