4.
Press
6
a second time to set the group to Priority
2. A "2" is displayed on line one.
5.
Press
6
a third time to set the group to Priority 1.
A "1" is displayed on line one. The priority level
selection sequence only advances the group to next
higher priority level and stops at priority level 1. To
select a lower priority level, the group must be de-
leted from the scan list and then added back to the
scan list. Each new group added to the scan list
starts at the lowest priority. If the Priority 1 and
Priority 2 groups are already set and a new group is
assigned as Priority 1 or Priority 2, the previously
assigned group will change to non-priority scanning.
One of the following messages may be momentarily
displayed:
SCAN DIS
The radio is not programmed to scan.
FIXED P1
A Priority 1 group has been pre-pro-
grammed into the radio. A new Priority 1
group cannot be selected.
FIXD LST
A fixed scan list has been pre-pro-
grammed into the radio. It is not possible
to change the list without reprogramming
the radio.
Note: To quickly view multiple group scan status,
press either
6
or the
9
key. Then slowly but
consistently rotate the group knob. Each group
status will appear on the display.
43
Summary of Contents for EDACS PRISM HP
