AXX 9100 CONNECT R1.2 Quick Reference Guide
3/1531-ZAP 701 14/1 Uen A 2006-10-16
16
1.6.3.2
Power Off
1.
Remove the AC adaptor power cable from the mains.
1.7
Installation of Service modules
1.7.1
General
This chapter describes installation procedures that are common to,
and independent of, the Service module type.
The Service Modules is described in the AXX 9100 CONNECT
Technical Reference.
Interconnections and cabling are descibed in “Interconnections and
cable handling” on page 1 -20.
N O T E !
Insertion or withdrawal of new modules does not affect the
other modules.
No manual configuration is needed, if a module is replaced
with a module of the same type.
All modules store inventory data in non-volatile memory. The
inventory data is accessible from the system controller and the
management system.
All modules contain a LED that indicates the status of the module.
See “LED - Module failure” on page 1 -18.
All modules supports hot insertion and removal. When a module
shall be replaced the switch shall be activated and the user must
wait for the LED to extinguish before the module is removed. It is
also possible to deactivate the module from the AXX 9820 CRAFT
terminal. A special tool, the Card Extraction Tool is needed to
activate this switch., see Figure 8
