35
3/1531-ZAP 701 14/1 Uen A 2006-10-16
AXX 9100 CONNECT R1.2 Quick Reference Guide
4.
The terminal application launches.
5.
Enter
COM port
name (e.g. com1) and select
OK
.
6.
An AXXCLI session is invoked by typing
axxcli
in terminal
window. User authentication (password, 8-12 ASCII characters)
is required, as the following session start-up sequence shows.
Default password is axxcli.
>
axxcli
--------------------------------------------------
AXX 9100 CONNECT Command Line Interface
--------------------------------------------------
Enter AXXCLI password:
******
AXXCLI>
7.
When access has been granted, you can define the following
AXX 9100 CONNECT parameters:
IP-Configuration(Management-Port):
Show-Current-Alarms:
Change-Passwords: Manage CLI/TELNET passwords
Erase-CDB:
Reset-Device:
Display-Debug-Info:
Clear-Debug-Info:
Community-Handler:
Management-Modes:
Running-Config:
Exit:
It is sufficient to type leading characters of the command name to
avoid ambiguity – the same applies to keywords. The BACKSPACE
or DELETE key may be used to edit the command line. Commands
and keywords are not case-sensitive. The Management Port IP
address is a compulsory parameter, and must be specified by you.
All the other parameters (except default gateway) are defaulted to
pre-defined values if they are not specified.
