7 of 12
3x
3x
M2.9 x 8 mm
2x
888-24-205-G-01 rev. C • 09/12
Capture the brake cable in the cable clip as
illustrated, then use a Phillips screwdriver to attach
the cable clips to bottom of work surface with the
provided M2.9 x 8 mm screws.
Using the 2 provided cable ties, attach brake cable
to the legs leaving as much slack in cable as possible
between the cable tie and the leg to allow desk top to
raise up unrestricted.
Set-up Steps
8
9
NOTE: Leave as much slack
in cable as possible between
the cable tie and the leg to
allow desk top to raise up
unrestricted. Failure to follow
this may result in equipment
damage.
777-24-038-G-00
WARNING
Keep Brake Cables Away from
Sync Rod and Crossbars
During Installation!
Failure to keep the brake cables away from
sync rod and crossbars may restrict lift
motion and may cause equipment damage
or personal injury! Refer to instruction
manual for more information.