5 of 12
Front =2 screws
Middle = 3 screws
Rear = 3 screws
8x
Front Edge of Worksurface
Rear Edge of Worksurface
# 12-14 Wood Screw
Set the right leg (with hand brake) upright on the
worksurface.
Partially insert 3 of the provided #12-14 wood
screws at the rear of the leg, 3 near the middle of
the leg and 2 at the front of the leg.
888-24-205-G-01 rev. C • 09/12
Place the worksurface on a clean fl oor with
the top side facing down.
Carefully position the leg with the hand
brake on the right end of the worksurface.
Place the other leg on the left end.
Attach one end of the rod to the right
leg as illustrated.
1
2
3
Set-up Steps
NOTE: The brake cable is attached to both legs. Take care when removing the legs
from the packaging to avoid damaging or pulling the brake cable from the legs.
NOTE: Do not fully
insert the screws
into the worksurface
at this time. Leave
approximately 1/8”
space.
777-24-038-G-00
WARNING
Keep Brake Cables Away from
Sync Rod and Crossbars
During Installation!
Failure to keep the brake cables away from
sync rod and crossbars may restrict lift
motion and may cause equipment damage
or personal injury! Refer to instruction
manual for more information.