6 of 12
9x
NOTE: Do not
fully insert
the screws
into the work-
surface at this
time. Leave
approximate-
ly 1/8” space.
# 12-14 Wood Screw
16x
M5 x 6 mm
888-24-205-G-01 rev. C • 09/12
6
5
4
Use a Phillips screwdriver to insert the
provided M5x6 mm screws into the two
crossbars connecting the left and right legs.
Tighten the screws slightly one at a time
and repeat to ensure that the tension on
every screw is equal.
Partially insert 9 of the provided #12-14 wood screws
in the left leg and worksurface.
Set the left leg (without
hand brake) upright on
the worksurface.
Attach the left end of
the rod to the left leg.
Use a Phillips screwdriver to tighten
down the screws attaching the legs to
the worksurface.
Set-up Steps
7
Rear = 3 screws
Front =3 screws
Middle = 3 screws
NOTE: Do not overtighten screws.
overtightening screws may result in
stripping the holes and may cause the
installation to be unsafe.
NOTE: Do not overtighten screws. overtightening
screws may result in stripping the holes and may
cause the installation to be unsafe.
777-24-038-G-00
WARNING
Keep Brake Cables Away from
Sync Rod and Crossbars
During Installation!
Failure to keep the brake cables away from
sync rod and crossbars may restrict lift
motion and may cause equipment damage
or personal injury! Refer to instruction
manual for more information.
777-24-038-G-00
WARNING
Keep Brake Cables Away from
Sync Rod and Crossbars
During Installation!
Failure to keep the brake cables away from
sync rod and crossbars may restrict lift
motion and may cause equipment damage
or personal injury! Refer to instruction
manual for more information.