11 of 12
=
14mm
1/4”
888-24-205-G-01 rev. C • 09/12
Release the hand brake (on the right leg) and move
the worksurface up to highest level.
Push aside the cover located behind each leg to
access the adjustment point.
Maintain equal amount of tension on both legs by
alternating the tension adjustment from one leg to
the other using a 14mm socket wrench.
Adjustment Step
14
Spin left to loosen tension
(for lighter loads).
Spin right to tighten tension
(for heavier loads).
Make sure
covers are fully
closed before
lowering the
worksurface.
NOTE: The covers on the legs will not
open unless the worksurface has been
lifted to it’s full height.
The worksurface will not lower unless the
covers have been completely closed.
WARNING! DO NOT tip desk over to adjust. Only perform
adjustment while desk is upright. Failure to follow these
instructions may cause the lift engine to expand rapidly and
may result in equipment damage and or personal injury.