Operating Instruction
Spindle lifting system SLA/SLG VD
Document no.: B-00081
Edition 2019 02
Operating instruction EN
Copyright by Ergoswiss AG
13/20
5
Operation
5.1
Drive up / down
This function is used for easy height adjustment of the system.
→
Press the button
or
.
Keep the button pressed until the desired working height is reached.
5.2
Duty cycle monitoring
The duty cycle monitoring checks for the operation/hold ratio. To avoid overheating of the system a duty
cycle of 2/40 (ON/OFF) should be maintained.
The maximum continuous operating time is 2 minutes. Afterwards a pause of at least 40 minutes needs to
be observed before the system can be operated again.
5.3
Saving a memory position
(Only with manual control switch type Memory!)
With this function it is possible to memorise a certain position/height and approach it at a later time by
pushing one button. With the three memory buttons up to three different positions can be stored and ap-
proached.
1.
Drive to the desired position and press the button
M
3 times.
2.
Press one of the buttons
1
2
3
.
A signal tone will ring after saving the memory position.
This operation can be repeated as often as you like and on any position.
5.4
Approaching a stored position
(Only with manual control switch type Memory!)
This function is designed to approach a stored position.
→
Keep one of the buttons
1
2
3
pressed.
The system approaches and stops at the stored position.
