Ergonomic products Safe-T-Shield, Manual

Page: 7 / 28

950-104revB www.ergonomic-products.com • 866-374-6487
Safe-T-Shield
TM
- Mobile
Item T1B1
7
3 - COMPONENTS AND ASSEMBLY INSTRUCTIONS cont.
ACCESSING FILTERS FOR INITIAL USE (AND REPLACEMENT)
Click here for a demonstration video or go to: www.ergonomic-products.com/safe-t-shield
The Safe-T-Shield is shipped with packing material below the three-part filtration system.
This must be removed prior to use to avoid damaging the motor ( step 6, below ).
When replacing filter, be sure the device is turned off and unplugged before opening the Housing.
Failure to do so may result in damage to the device and injury to the operator.
ASSEMBLY OVERVIEW
The Safe-T-Shield requires only minor assembly, and no tools are needed.
1. Remove the filters to access and remove the packing material from the Main Filter Assembly
2. Attach the Housing Lid & Riser Tube
3. Plug in the power and remote control cords.
4. Install the Shield (visor)
Details on each step are provided in the following pages, and demonstration videos are available.
1. If Housing Lid is in place, unlatch the four black latches on the underside of the Lid (fig. 3.1).
Place Lid and upper assembly on floor carefully to avoid damage to the Shield.
2. Carefully lift off and remove the black Filter Gasket from the Main Filter Assembly (fig. 3.2).
3. Remove the Primary Cotton Filter (fig 3.3).
3.1 3.2 3.3