Ergon Crafco 46200EB, Parts Manual, Page: 43 / 202

EZ 1000 Series II Melter Part Manual
Chapter 5 Operating Instructions
©2019 by Crafco, Inc. All Rights Reserved………………..…………………………………..….Operating Instructions 5-17
Step Action
1 Close recirculation valve and reverse the pump for approximately 3 minutes.
1a Remove wand from hose and wrap hose up in oven while reversing the pump.
2 Close the “APPLICATOR VALVE”.
3 Open recirculation valve. Close the “TANK VALVE”.
4 Turn “Off” pump reverse switch.
5 Turn the mixer toggle switch to the “OFF” position.
6 Turn the “Power” switch to the “OFF” position.
7 Stop the engine by turning the key to the “OFF” position.
IMPORTANT : Ensure the hose is not touching the tank wall or plumbing.
Step Action
1 Close recirculation valve and reverse the pump for approximately 3 minutes.
1a Remove wand from hose and wrap hose up in oven while reversing the pump.
2 Close the “APPLICATOR VALVE”.
3 Open recirculation valve. Close the “TANK VALVE”.
4 Turn “Off” pump reverse switch.
5 Turn the mixer toggle switch to the “OFF” position.
6 Turn the “Burner” switch to the “OFF” position.
7
Stop the engine by pressing the “OFF” button once. This will throttle down the engine
and shut it “OFF”. It will continue to run for a few seconds.
8 Turn “OFF” key switch.
IMPORTANT: Ensure the hose is not touching the tank wall or plumbing.
Table 5-18 Shutting Down 46200SB
Table 5-19 Shutting Down 47600SC100