Ergon Crafco 46200EB, Parts Manual, Page: 42 / 202

EZ 1000 Series II Melter Part Manual
Chapter 5 Operating Instructions
©2019 by Crafco, Inc. All Rights Reserved………………..…………………………………..….Operating Instructions 5-16
Step Action
1 Leaving the hose in the boom, swing the boom clockwise towards the front of the
machine and lock the boom into position with the latch provided.
CAUTION
DO NOT kink or twist the hose or permanent damage may result.
2
Place the wand in the wand holder and lock the wand into position with the latch
provided.
3
Reverse the pump while removing tip adapter and or duckbill. Continue to reverse for
approximately 30 more seconds.
4 Close the “APPLICATOR VALVE” and “TANK VALVE”.
5 Turn the mixer toggle switch to the “OFF” position.
6 Turn the “POWER” switch to the “OFF” position.
7 Stop the engine by turning the key to the “OFF” position.
Step Action
1 Leaving the hose in the boom, swing the boom clockwise towards the front of the
machine and lock the boom into position with the latch provided.
CAUTION
DO NOT kink or twist the hose or permanent damage may result.
2
Place the wand in the wand holder and lock the wand into position with the latch
provided.
3
Reverse the pump while removing tip adapter and or duckbill. Continue to reverse for
approximately 30 more seconds.
4 Close the “APPLICATOR VALVE” and “TANK VALVE”.
5 Turn the mixer toggle switch to the “OFF” position.
6 Turn the “Burner” switch to the “OFF” position.
7
Stop the engine by pressing the “OFF” button once. This will throttle down the engine
and shut it “OFF”. It will continue to run for a few seconds.
8 Turn “OFF” key switch.
Table 5-16 Shutting Down 46200EB
Table 5-17 Shutting Down 47600EC100