How to use this device
68/92
–
Remove the lamp coverings at the head and foot ends.
Replace the lamps: see page 63.
Replace the starter: see page 65.
–
Remove the partition and carefully set aside (only for devices with an air
conditioning unit).
The assembly is the same process in reverse order.
When assembling the device please note:
–
When positioning the lamp covering push the pins into the opening.
WARNING!
Crushing hazard due to improper maintenance!
If the acrylic panel is mounted backwards, there will be a
gap between front panel and acrylic panel.
–
Always replace the acrylic panel as shown: The imprint
on the panel must be next to the foot end at the rear
side of the device.
–
Carefully lay the acrylic panel in the guide.
12.16.7
Cleaning or replacing the UV lamps in the
side section
Not applicable for this device.