Erbauer ERB617SDR, Manual

Page: 15 / 24

240W 1/3 SHEET SANDER ERB617SDR
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the
instruction book carefully.
INTENDED USE:
The machine is intended for dry sanding of wood,
plastic, filler and coated surfaces.
1. FITTING THE SANDING PAPER (SEE FIG 1,
2 & 3)
To fit the sanding paper, lift up the clamp lever and
move away from the clamp lever lock. The sanding
paper clamp is now loose. Repeat with the other
clamp on the opposite side of your sander.
To fit new sanding paper, insert approximately
5mm of one end of the sanding paper under the
sanding paper clamp until the paper contacts the
housing wall. Lift up the clamp lever and move it
to the lever lock position. Press the sanding paper
around the base plate shape as tight as possible
and fix the end under the other sanding paper
clamp.
Check the sanding paper is square to the
baseplate. If not correct, remove and refit it again.
Always, ensure the sanding paper is tight over the
baseplate and secured underneath both locked
clamps. This will ensure safe and efficient sanding
performance.
For hoop & loop sanding paper, Align the sanding
sheet and press it onto the sanding pad by hand.
Firmly press the power tool with the sanding sheet
against a flat surface and briefly switch the power
tool on. This provides for good adhesion and
prevents premature wear.
2. DUST BOX (SEE FIG. 4-1, 4-2)
Your sander is equipped with dust box. To attach,
insert the dust box into the back of the sander until
it is secure. To remove, press the release lever on
both sides and slide the dust box out.
Caution:
To prevent the possibility of sanding dust
or foreign body being thrown into your face or
eyes, never attempt to use your sander without the
cyclone box properly installed.
Fig. 1
Fig. 2
Fig. 3
Fig. 4-2
Fig. 4-1
Fig. 5-1
Fig. 5-2
Fig. 6
Fig. 7
Fig. 9
Fig. 10
Fig. 8