Erbauer ERB617SDR, Manual

Page: 17 / 24

240W 1/3 SHEET SANDER ERB617SDR
Sanding
metal and
steel
120 240 9800~11000 5~max
Sanding
plexiglass
180 400 6500~8700 2~4
5. PAPER PUNCH (SEE FIG. 8)
If using sanding paper without dust holes, use
the paper punch to perforate the holes to ensure
correct dust extraction. Position the punch over
the base plate with the punch sides on the edges
of the base plate. Press the punch into the base
plate to punch holes into the sanding paper. Then
remove the punch and check all the holes have
been formed correctly.
6. USING THE SANDER
The workpiece to be sanded must be secured. If it
is small or it may move during sanding, it must be
held in a vice or suitably clamped.
Be sure to hold the sander firmly whilst it is on and
apply it gently to the work, it may “kick” on first
contact. Hold the sander so that it is flat on the
work and move slowly, preferably with a smooth,
circular motion. Regularly check the condition of
the sanding paper and replace when worn for best
results.
7. FLUSH SANDING FACILITY (SEE FIG. 9)
Your sander can sand flush on three sides of the
baseplate which allows easy access to corners and
edges of mouldings.
8. ORBITAL SANDING
Your sander operates in small a circular rotation
which allows efficient material removal. Operate
your sander in long sweeping movements across
your workpiece and even across the grain. For a
finer finish, always use a fine grain sanding paper
and only move the sander in the direction of the
grit and never across the grain. Do not allow your
sander to remain in the same position otherwise
you will remove material and create an uneven
surface.
Fig. 1
Fig. 2
Fig. 3
Fig. 4-2
Fig. 4-1
Fig. 5-1
Fig. 5-2
Fig. 6
Fig. 7
Fig. 9
Fig. 10
Fig. 8