Erbauer ERB617SDR, Manual

Page: 18 / 24

9. ATTACHING SANDER TO VACUUM (SEE
FIG.10)
Your sander is equipped with a vacuum adapter
(8), which is designed for collect dust task. Insert
the adapter (8) into the rear dust outlet of sander.
Then pull the dust tube and make sure it is
tightened securely on the dust outlet. Then connect
the hose of a vacuum cleaner.
First please turn on the vacuum cleaner, and then
turn on the sander. If you stop sanding, first turn off
the sander, then turn off your vacuum cleaner.
Note!
please always connect the adaptor with 35mm
vacuum hose.
WORKING HINTS FOR YOUR SANDER
1. If your power tool becomes too hot, especially
when used at low speed, set the speed to
maximum and run it with no load for 2-3 minutes to
cool the motor. Avoid prolonged usage at very low
speeds. Always use sand paper that is suitable for
the material you want to sand.
2. Always ensure the work-piece is firmly held or
clamped to prevent movement.
3. Any movement of the material may affect the
quality of the sanding finish.
4. Start your sander before sanding and turn it off
only after you stop sanding. For the best results,
sand wood in the direction of the grain.
5. Do not start sanding without having the
sandpaper fitted.
6. Do not allow the sandpaper to wear away it will
damage the base-plate. The guarantee does not
cover base-plate wear and tear.
7. Use coarse grit paper to sand rough surfaces,
medium grit for smooth surfaces and ine grit for the
final surfaces. If necessary, first make a test run on
scrap material.
8. Use only good quality sandpaper.
9. The sandpaper controls the sanding efficiency,
not the amount of force you apply to he tool.
Excessive force will reduce the sanding efficiency
and cause motor overload. Replacing the
sandpaper regularly will maintain optimum sanding
efficiency.