Erbauer ERB389JSW, Manual, Page: 16 / 24

I
Hard materials, (e.g. steel &
chipboard)
II
Thick materials ( e.g. wood )
& plastic
III Fast cuts (e.g. softwood).
Cutting in the
9. BASE PLATE
Adjusting the angle of the base plate (7) enables
bevel cutting. The base plate must always be held
irmly against the materials being cut to reduce
saw vibration, blade jumping or blade breakage.
10. BASE PLATE ANGLE ADJUSTMENT
Use a Hex Key (5). Loosen the bolts securing the
base plate (See Fig.8) . For preset angles rotate so
the lines of the angle on the base plate and angle
plate (8) superposition at the desired angle (0, 15,
30, 45)
(See Fig.9)
. For other mitre angles, rotate
to your desired angle (use a protractor scale).
Following one of the above procedures, hold the
base plate in position and irmly tighten the bolts to
clamp the base plate at that angle. Finally, check the
angle and ensure the base plate is irmly clamped.
The angle markings on the base plate are accurate
for most general purposes but it is recommended
for accurate work to set the angle with a protractor
and make a test cut on other material.
11. DUST TUBE (See Fig.10)
Mount the dust tube (6) into the opening of the
base plate (7). Make sure that the plastic tip
of the vacuum connection engages into the
corresponding opening on the housing as shown in
the igure.
12. PROTECTION FINGER WIRE
The inger wire is located in front of the blade
holder. Whilst working, it will help prevent
accidental contact with moving blade.
13. DUST BLOWER AIR HOLE
This is a small aperture located underneath the
housing just behind the blade guide. Ensure this is
kept clean to allow the air low to continually blow
Fig 8
Fig 9
Fig 10
8
8
7
6