Erbauer ERB389JSW, Manual, Page: 15 / 24

710W JIGSAW
To open the blade holder (13) rotate the ring
anti-clockwise (Jigsaw upside down) and hold in
position (See Fig.4). Then fully insert the blade
into the blade holder slot with blade teeth facing
forward and release the ring, which will self rotate
and clamp over the top of the blade. Push the
blade into the blade holder again to ensure it is
locked in position. Ensure the edge of the blade
is located in the groove of the blade guide (See
Fig.5). To remove a blade, holds the blade and
rotate the blade holder ring anti-clockwise then lift
out the blade (blade could be spring ejected).
Warning: Blade teeth are very sharp. For
best cutting results ensure you use a blade
suited to the material and cut quality you need.
6. MOUNTING PARALLEL GUIDE
(See Fig.6-1, 6-2.)
First slide the parallel guide clamp (a) and locking
knob (b) onto the parallel guide (15). Then slide
the parallel guide arm through both parallel guide
ixtures and place the clamp (a) on the ixture.
Tighten the locking knob (b) to achieve the
required cutting distance. The parallel guide can
be mounted in two positions as shown in F6-1 and
F6-2.
7. ROLLER GUIDE
Ensure the blade is located and runs smoothly in
the groove (See Fig.5) otherwise the pendulum
function will not work correctly and the blade will
not be supported during cutting.
8. PENDULUM ACTION CONTROL (See Fig.7)
The pendulum action varies the forward cutting
angle of the blade for increased cutting eficiency.
This can also be adjusted during no load running.
Refer to the chart 2 for more details. Do not use
excessive blade force when cutting with the
pendulum action. The blade cuts on the upward
stroke only.
Chart 2
0
Thin materials. Fine cuts.
Tight curves.
Fig 5
10
Fig 6-1
Fig 6-2
Fig 7
a
b
15
9