Erbauer 5059340010762, Original Instructions Manual

Page: 32 / 44

32
Additional tips for impact drilling
NOTE: In principle, drill masonry in impact drilling mode with maximum
speed. However, in the first few seconds, the drill bit may deviate from
the original desired position due to the impact action. To avoid this, use
inching impact mode or drill mode with low speed and low feeding force
before the drill bit tip is well seated in workpiece.
Pay special care to drill tiles. Impact can damage the tile! Use special tile
drill bit with drill mode without impact to drill through the tile first!
Then switch to impact drilling mode for the brick/concrete behind the tile.
Drilling tile with normal masonry drill bit in impact drilling mode is ONLY
for experts!
02
Screw driving
1. Rotate the function selection ring (3) to screw driving mode.
2. Rotate the torque pre-setting ring (2) and adjust the torque setting (numbers)
according to the screw size and workpiece material.
3. Pre-drill the holes with a smaller diameter than the screw to be driven.
4. Hold the product perpendicular to the screw to be driven in/out. Holding it at an
angle may cause slipping or jamming of the driver bit.
5. Place the tip of the driver bit directly on the screw first and then switch the product
on.
6. Only apply as much pressure as necessary to keep the screw in place and the
driver bit in contact with the screw head. Too much pressure will cause damage
to the screw head and driver bit, too little pressure will cause the driver bit to slide
away.
7. Remove blocked and stuck screws by changing the rotational direction.
After use
1. Switch the product off, remove the battery back and let it cool down.
2. Check, clean and store the product as described below.
MNL_Erbauer_ECD12-Li-2_GB_12V Combi Drill_V10_210422.indd 32 4/22/21 6:20 PM