Erbauer 5059340010762, Original Instructions Manual

Page: 29 / 44

29
05
Function selection ring
Three working modes are available on this tool: drilling, screw driving and impact
drilling. To select any of the three modes, rotate the function ring to align it with icon of
the drill/screwdriver/ hammer on the housing, depending on the function you desired
(Fig. O).
Screw driving mode for driving screws
Drilling mode for drilling into wood, plastic and metal
Impact drilling mode for impact drilling into brick, concrete
06
Torque pre-setting ring
In screw driving mode, the torque can be adjusted by rotating the torque adjustment
ring (Fig. P). Higher number means higher torque. Select the setting as follows:
1-5 for driving small screws
6-10 for driving screws into soft material
11-15 for driving screws into soft and hard material
16-20 for driving screws into hard wood
07
Automatic spindle lock
The automatic spindle lock allows you to use it as a regular screwdriver. You can give
an extra twist to firmly tighten a screw, loosen a very tight screw or continue working
when the battery energy has expired. For manual screwdriver purposes, the chuck is
automatically locked when the tool is off.
08
Automatic work light
The LED work light (11) will illuminate when the trigger of On/Off switch (12) is
depressed slightly, and will automatically turn off a short while after the trigger of On/
Off switch (12) is released (Fig. Q). This provides additional light on the surface of the
workpiece for operation in lower light situations.
WARNING! Do not look directly into the light.
MNL_Erbauer_ECD12-Li-2_GB_12V Combi Drill_V10_210422.indd 29 4/22/21 6:20 PM