Erbauer 5059340010762, Original Instructions Manual

Page: 28 / 44

28
03
Forward / reverse rotation control
Change the rotational direction from forward to reverse by pressing the forward /
reverse rotation control (6).
WARNING! Only change the rotational direction when the product is
switched off and has come to a complete stop! Always ensure that the
forward / reverse rotation control (6) is adjusted to the correct position
depending on the intended operation!
Always push the forward / reverse rotation control (6) as far as it will go!
Do not use the product with the control switch in any other position!
1. Move the forward / reverse rotation control (6) to the left (as seen from the
operator`s position) in order to use the product in a clockwise rotational mode
(Fig. L).
2. Move the forward / reverse rotation control (6) to the right (as seen from the
operator`s position) in order to use the product in anticlockwise rotational mode
(Fig. M).
04
Two-speed gear control
The combi drill has a two-speed gear control designed for drilling or driving at low or
high speeds. The gear selector switch (4) is located on top of the combi drill to select
either low or high speed (Fig. N).
When using the combi drill in the low speed range, the speed will decrease and the
combi drill will have greater power and torque.
When using the combi drill in the high speed range, the speed will increase and the
combi drill will have less power and torque.
Gear 1:
Low speed range: for screw driving or working with large drilling diameter.
Gear 2:
High speed range: for working with small drilling diameter.
WARNING! Only change the two-speed gear control when the product is
switched off and has come to a complete stop.
Always slide the gear selector switch (4) as far as it will go.
MNL_Erbauer_ECD12-Li-2_GB_12V Combi Drill_V10_210422.indd 28 4/22/21 6:20 PM