EN
16
the saw blade or making adjustments to the riving knife, anti-kickback device
or saw blade guard, and after each completed cutting procedure.
Precautionary
measures serve to avoid accidents.
b)
Never leave the table saw unattended when in operation. Turn if off and don't
leave the tool until it has come to a complete stop.
An unattended running saw
is an uncontrolled hazard.
c)
Locate the table saw in a well lit and level area where you can maintain good
footing and balance.
It should be installed in an area that provides enough room
to easily handle the size of the workpieces. Cluttered, dark areas, and uneven
slippery floors invite accidents.
d)
Regularly clean and remove wood shavings and saw dust from under the
saw table and/or the dust extraction unit.
Accumulated saw dust is combustible
and may self ignite.
e)
Secure the circular table saw.
A circular table saw that is not properly secured
may move or tip over.
f)
Remove tools, wood scraps etc. from the table saw before turning it on.
Distraction or possible jams can be dangerous.
g)
Always use blades of the right size and with the appropriate mounting hole
(e.g. starshaped or round).
Blades that do not match the mounting hardware of
the saw will run off-centre, causing loss of control.
h) Only use 10" saw blade with kerf width of 2.8mm and blade body thickness is
1.8 mm match the riving knife with thickness of 2.3 mm.
i)
Always use only a saw blade diameter in accordance with the markings on
the saw; Use only saw blades for which the maximum possible speed is not
less than the maximum spindle speed of the product.
h)
Never use damaged or incorrect saw blade mounting means such as flanges,
saw blade washers, bolts or nuts.
These mounting means were specially
designed for your saw, for safe operation and optimum performance. Do not use
any blunt, cracked, deformed or damaged saw blades. Only replace the saw blade
with one complying with the European standard EN 847-1.
i)
Never stand on the table saw, do not use it as a stepping stool.
Serious injury
could occur if the tool is tipped or if the cutting tool is accidentally contacted.
j)
Make sure that the saw blade is installed to rotate in the proper direction.
Do not use grinding discs or wire brushes on a table saw.
Improper saw blade
installation or use of accessories not recommended may cause serious injury.
5. Additional safety instructions
- These operating instructions are intended for people with basic technical knowledge
regarding the operation of a machine like this or similar electrical power tools.
Inexperiencend persons are strongly advised to seek competent advise and guidance
from an experienced person before operating this machine.
- The manufacturer assumes no liability for any damage caused by neglect of these
operating instructions.
- Please also observe the special safety instructions in the respective chapters.
- Where applicable, follow the legal directives or regulations for the prevention of
accidents pertaining to the use of table saws.
