EN
33
10
Attach the table saw body on the foldable stand (Fig. V)
1. Place the foldable stand (11) on a flat surface.
2. Place the table saw body on top of the foldable stand (11), aligning the holes in the
table saw body with the holes in the foldable stand (11). Make sure that the front of
the table saw body is facing the locking knob (11) as shown on Fig. V.
3. Insert the four hex bolts (M8 x 35 mm) into flat washers and the aligned holes (35).
Tighten all four hex bolts with provided 6 mm hex key (34).
11
Attach the table saw body on the workbench (without foldable stand)
If the foldable stand is not to be used, the table saw body must be properly secured to
a sturdy workbench using the four mounting holes on the saw base.
1. Place the table saw body over the workbench tabletop and mark four locations on
top of the workbench that correspond to the mounting hole positions.
2. Drill four mounting holes (Ø8 mm) at the marked location of the workbench.
3. Place the table saw body on the workbench and align the mounting holes of the
table base with the drilled holes in the workbench.
4. Firmly secure the table saw body to the bench surface.
5. Carefully check the workbench after mounting to make sure that no movement can
occur during use. If any tipping, sliding, or other movement is noted, secure the
workbench to the floor before operating.
4. Attach flat washers (72), hex locking nuts (71), support feet (29) and wingnuts (70).
Make sure the “ON” and “OFF” marking toward the leg (not ground). Secure in place
by tightening the hex locking nuts (71) and wingnuts (70). The wheel should rotate
smoothly.
5. Secure the stand with the screws (not supplied) from the mounting holes (Ø8 mm)
on the support feet (29) to the floor if necessary.
