QuadroCS Manual II: Administrator's Guide
Administrator's Menus
Quadro
CS
(SW Version 3.0.x)
5
Recurrent Buttons
Button Description
Button Description
This button leads back to the previous page of
a fixed sequence of pages (used mainly in
wizards).
This button leads back to the page you have been on
before.
This button leads onward to the next page of a
fixed sequence of pages (used mainly in
wizards).
This button confirms an operation you started before.
This button discards the latest, not yet
confirmed entries.
This button confirms an operation you chose before.
This is the last button of a fixed sequence of
pages that completes and saves the entries of
the whole sequence.
This button discards an operation you chose before.
This button has the same function like the
"
?
"
in the left button bar. It opens the help page
belonging to the currently active QuadroCS
management page.
This button saves the settings modified on the
currently active management page.
This button opens a window where the last inserted IP
addresses are listed. It is a clipboard that helps the
user to make quick selection of an IP address in case it
has been already used in the past, thus to avoid typing
it again. The clipboard can hold up to 10 IP addresses,
a new IP address will replace the oldest one from the
list.
Recurrent Functional Buttons of the GUI
In connection with tables, the following buttons - among others - usually occur:
Functional Button
Description
Add
Allows adding a new record to the displayed table. A new page will be displayed to enter the new settings.
Edit
Allows modifying the settings of the record selected by its checkbox. Normally only one record may be selected. A new
page will be displayed to enter the modified settings.
Delete
Deletes the selected entry(s) of a table. A warning message will demand a confirmation before deleting an existing entry.
Select All
Selects all table entry(s) for example for further deletion.
Inverse Selection
Inverts an existing selection of table entry(s). If no entries are selected, clicking the button will select all records.
Refresh in...
May occur in the lower right corner of a page. It displays the number of seconds remaining until the next refresh of the
page and may be used to reload the page manually.
Most of the tables offer the option to sort the entries in ascending or descending order by clicking the headings of the columns. A small arrow beside
the column heading will show the direction of sorting – upward or downward.
The entries of the table can be selected by the assigned checkboxes - one at a time, for the most part - in order to edit or delete them.
Entering a SIP Addresses correctly
Calls over IP are implemented based on Session Initiation Protocol (SIP) on the QuadroCS. When making a call to a destination that is somewhere
on the Internet, SIP address must be given.
SIP addresses have to be specified in one of the following formats:
“display name” <username@ipaddress:port>
“display name” <username@ipaddress>
username@ipaddress:port
username@ipaddress
username
The display name and the port number are optional parameters in the SIP address. If the port is not specified, 5060 will be set up as the default one.
The range of valid ports is between 1024 and 65536.
A flexible structure of wildcards is allowed. In comparison with a wildcard, the “?” character stands for only one unknown digit and the “*” character
stands for any number of any digits.
Particularly the following combinations can be used for your convenience:
-
*@ipaddress
- any user from the specified SIP server.
-
username@*
- a specified user from any SIP server.
-
*@*
- any user from any SIP server.
Please Note:
Wildcards are available for caller addresses
only. No wildcard characters are allowed for called party
addresses. To use “*” and “?” themselves (as non wildcard
characters), use “\*” and “\?” correspondingly
