Quadro Manual I: Installation Guide
Step 2.2: Basic Configuration
Quadro2x, 2xi, Quadro4x, 4xi, 4xa, 4xia, 4xs, 4xis, Quadro16x, 16xi, 16xa, 16xia, 16xs, 16xis; (SW Version 3.0.x)
22
On the
Uplink Configuration
page, select the desired WAN interface protocol.
Fig. I-21: Uplink Configuration page
5.
Specify the
WAN Interface Bandwidth
. If you know what upstream/downstream
bandwidth you get from your ISP, enter the values here. For basic DSL and cable mo-
dem in the US, typical values are
300
for Upstream and
1500
for Downstream.
These settings regulate the number of calls allowed by the Quadro to avoid degrada-
tion during low bandwidth conditions. The Quadro uses the G.726-32 Codec by default,
which consumes 48 kbps for each call. For more information on other available codecs
and their bandwidth consumption, refer to the online help pages or the Administrator’s
Guide.
The
Min Data Rate
field specifies the amount of bandwidth reserved for data
applications. The value entered here must be smaller than the value specified in the
Upstream Bandwidth
field. Typically this value is set to zero (0).
6.
Click
Next
until you reach the last page of the Internet Configuration Wizard. To com-
plete the basic Internet configuration and save the settings, click the
Finish
button. The
Confirm Settings
page will be displayed. You must click
OK
to confirm the changes.
Fig. I-22: Confirm Settings page
Please Note:
You have to confirm the settings within 20 minutes; otherwise, the
Quadro will
restore the previous configuration and reboot
.
Summary of Contents for Quadro 16xa
Page 1: ......
