Code
Problem
Solution
106
Cannot print from the computer due to the access
control settings.
Contact your printer administrator.
107
User authentication failed. The job has been
canceled.
❏
Make sure that the user name and password are
correct.
❏
Select
Settings
>
General Settings
>
System
Administration
>
Security Settings
>
Access
Control
. Enable the user restriction function, and
then allow the job without an authentication
information.
108
Confidential job data was deleted when the printer
was turned off.
-
109
The received fax was already deleted.
-
110
The job was printed on one side only because the
paper loaded does not support double sided
printing.
If you want to perform 2-sided printing, load paper
that supports 2-sided printing.
201
The memory is full.
❏
Print received faxes from
Job Status
in
Job/
Status
.
❏
Delete received faxes saved in the inbox from
Job
Status
in
Job/Status
.
❏
If you are sending a monochrome fax to a single
destination, you can send it by using Direct Send.
❏
Divide your originals in two or more to send them
in several batches.
202
The line was disconnected by the recipient machine.
Wait for a while and then try again.
203
The product cannot detect the dial tone.
❏
Make sure that the phone cable is connected
correctly and the phone line is working.
❏
When the printer is connected to the PBX or the
terminal adapter, change the
Line Type
setting to
PBX
.
❏
Select
Settings
>
General Settings
>
Fax
Settings
>
Basic Settings
>
Dial Tone
Detection
, and then disable the dial tone setting.
204
The recipient machine is busy.
Wait for a while and then try again.
205
The recipient machine does not answer.
Wait for a while and then try again.
206
The phone cable is incorrectly connected to the LINE
and EXT. port of the product.
Check the connection of the LINE port and the EXT.
port of the printer.
207
The product is not connected to the phone line.
Connect the phone cable to the phone line.
208
The fax could not be sent to some of the specified
recipients.
Print a
Fax Log
or
Last Transmission
report for
previous faxes from
Fax Report
in the Fax menu to
check the failed destination. When the
Save Failure
Data
setting is enabled, you can resend a fax from
Job Status
in
Job/Status
.
User's Guide
Solving Problems
183