36
Maintaining Your All-in-One
4. Remove the cartridge from the package, but be careful not to
touch the green chip on the edge.
5. Remove the yellow tape from the bottom of the ink cartridge.
Caution:
Do not remove any other labels or seals, or ink will leak.
6. Insert the new ink cartridge into the holder and push it down
until it clicks into place.
7. Once you replace all the cartridges that need replacing, close the cartridge
cover and push it down until it clicks into place.
8. Close the scanner.
9. Press
OK
to begin charging the ink. This takes about 2 minutes. When you
see a completion message on the display screen, ink charging is finished.
Caution:
To conserve ink, never turn off the RX680 Series while ink is charging. If you see an ink
replacement message on the display screen, press
OK
and press down all the
cartridges securely.
If you remove a low or expended ink cartridge, you cannot reinstall and use the
cartridge.
sprx680_qg.book Page 36 Wednesday, June 6, 2007 8:40 AM
