Epson PX650 Series, Service Manual

Page: 149 / 166

Epson Stylus Photo PX650/TX650/TX659/PX660/PX660 Premium/Artisan 635 Revision C
Epson Stylus Photo PX660/PX660 Premium/Artisan 635 Disassembly/assembly 149
Confidential

When attaching the Panel Gear to the Panel Unit, align the
protrusion of the Panel Unit with the groove of the Panel Gear.
Figure 8-9. Installing the Panel Unit (1)

When installing the Pane Unit, align the positioning holes (x2
each) of the Panel Hinges with the dowels (x2 each) of the M/B
Covers.
(See Figure 8-7.)

Make sure that the Panel Unit moves smoothly after installing
the Panel Unit.

Make sure of the following when attaching the Panel Sheet.

Before attaching the Panel Sheet, wipe off the adhesive left
on the Panel Unit surface thoroughly with a soft cloth
moistened with diluted alcohol.

Taking the top left corner of the Panel Sheet as the reference
point, align the top edge with the top rib of the Panel Unit
and put the left edge against the rib, then attach the Panel
Sheet without any lifting.
(See Figure 8-8.)
Panel Unit
Panel Gear
Rear of Panel Unit
Protrusion and groove

Route the grounding wire through the groove of the M/B Cover as
shown in
Fig. 8-6 and secure it to the Main Board with the screw.

When installing the Panel Unit, make sure to engage the point
A and B of the Panel Gear with the M/B Cover properly as
shown below.

Point A: Insert the ribs (x3) of the Panel Gear to the grooves
(x3) of the M/B Cover.

Point B: Insert the small box of the Panel Gear to the hole
of the M/B Cover.
Figure 8-10. Installing the Panel Unit (2)
A D J U S T M E N T
R E Q U I R E D
After removing/replacing the Panel Unit, make the specified
adjustments. (See
"8.3 Adjustment" (p.157) .)
Panel Gear
Point B
Panel Unit
Panel Gear
Point A
M/B Cover
Rear of point A
Panel Gear
Rib
Groove
Small box
Hole