Epson PhotoPC600, Service Manual, Page: 95 / 116

PhotoPC600
Chapter5 Adjustment
Rev. A 5-2
The table below shows required tools and equipment for adjustments.
Table 5-2. Required Tools and Equipment
No. Name Purchasable Code
1 5100 Kelvin color Viewer X 103058400
2 DscCal52 adjustment program X Attached with this manual book.
3 Simens star chart X Included in the end of this book.
4 Precision Driver (+) O ----
5 Soldering iron O B740200100
6 Tweezers O B641000100
7 Oscilloscope O ---
8 Windows95 (require 19200bps or
higher for serial) O ---
Note): O means commercially available and X means not.
CAUTION
There are only 3 supply units of electrical parts on the board except for
lens unit on the CA1 board; 1) Two cables of ST1 board (F3102 and
F3103), 2)Flash unit 3)Main Electrolytic Capacitor. Therefore, even if
other parts except 3 units above are replaced, there is no adjustment
written about it. Therefore we prohibit to replace or exchange individual
electrical elements on the each board.
5.1.1 Preparation for Adjustment
This section explains Camera and PC set up before starting adjustment.
SETTING UP PC
Step1. Use PC with Windows
â
95. (Refer to CAUTION below for details)
CHECK POINT
ü ü ü ü
n n n n
IBM(-compatible PC with 486 or higher processor)
n
n n
n
3.5-inch high-density diskette drive
n n n n
Serial port with standard RS-232C interface
n n n n
8MB RAM
n n n n
Hard disk drive with at least 15MB available
n
n n
n
VGA or SVGA monitor with at least 256-color display
Step2. Insert the calibration software diskette into your diskette drive.
Step3. By double-clicking on “Setup. EXE” in the disk, a directory c:\DscCal52\ is
automatically made, and program is installed and completed.