Epson PhotoPC600, Service Manual, Page: 53 / 116

PhotoPC 600
Chapter4 Disassembly and Assembly
Rev. A 4-4
4.1.4.1 Removing the Cabinet Parts
The figure below shows disassembling of Cabinet Assembly (Rear and Front), Top Cover and
Battery Cover.
4. Screw 2x5
(#101)
Grip
1. Screw 2x5
(#100)
6. Screw 2x5
(#100)
5. Open this cover
by pressing the lever for
the card.
2. Open the cover.
7. Remove a connector
for TB1.
8. Remove the FPC.
9. Remove a connector
for power supply.
10. Screw 2x5
(#100)
11. Remove the top cover.
Figure 4-3. Procedure for Disassembly (1)
WARNING
There is a danger of getting electric shock from the electrolytic
capacitor(C5412) mounted on the ST1 board. Discharge the electricity
by using the cement resistor when you need to touch the ST1 Board for
repair service. (See the figure below for details.)
CAUTION
Be careful not to damage the hook inside of grip when you remove the
top cover at “11” in the figure above. Also, pay attention not to scratch
the grip surface by that hook.
A v o i d g e t t i n g e l e c t r i c
s h o c k b y u s i n g i n s u l a t i n g t a p e .
U s e t h e r e s i s t a n c e a t l e a s t
5 6 0 o h m s / 1 0 W .
S T 1 B o a r d
C 5 4 1 2
N o f i x e d
d i r e c t i o n
Figure 4-4. Discharging Electricity