Epson PhotoPC600, Service Manual, Page: 59 / 116

PhotoPC 600
Chapter4 Disassembly and Assembly
Rev. A 4-10
ASSEMBLY OF SHUTTER MECHANISM (REFER TO FIGURE4-11)
Step4. Pierce the tension spring to the dimple for determining position. At this time, the
peaking point of the tension spring should be towards you. Then, fix it with
a screw 2x4(Black).
Step5. Put the peaking of the spacer ring to the hole of the cover lens. A.
Step6. Put the peaking of the spacer ring to the hole of the cover lens. B.
CHECK POINT
ü ü ü ü
n n n n
At this time, Leave the shutter closed with the cover lens A and B.
Step7. Put the lever ring to the peaking of the spacer ring.
CHECK POINT
ü ü ü ü
n n n n
At this time, Install the lever ring as if the 2 peaking points of the
lever ring wrap the cover lens A and B.
Step8. Put the holder ring over and adjust position so that 3 screw holes match to 3 holes
of the spacer ring. Then fix them with 3 screws 2x5(#100).
INSTALLING THE POWER SUPPLY ON/OFF SENSOR (REFER TO FIGURE4-12)
Step9. Leave the power supply(spacer ring) Off.
Step10. Fix the power supply sensor with one screw 2x5(#100), referring to the figure4-12.
CHECK POINT
ü ü ü ü
n n n n
Locate black and red cables so that a dimple for insulation comes
between these two cables in order to avoid two cables getting short.