4. Connections
ICDmini Ver. 3.0 User Manual
Seiko Epson Corporation
9
(Rev. 1.0)
4.2 Connecting to the Host Computer
Use the USB cable included in this package to connect the ICDmini Ver. 3.0 to the host computer. When the
ICDmini Ver. 3.0 is connected to the host computer for the first time, the host computer requests the USB driver
to be installed. Instal the USB driver by following the directions displayed by the host computer. (For detailed
information on the operations, refer to the manual for the S1C17 Family C Compiler Package Ver. 3.0.0 or later.)
If the driver has already been installed, the POWER (green) LED on the ICDmini Ver. 3.0 top panel starts
blinking and then it changes to lighting when the communication between the ICDmini Ver. 3.0 and the host
computer is established.
In addition to the POWER LED, the EMU (red) LED lights if power to the target system has been turned on and
the target S1C17 MCU is ready to start debugging.
Note!
The VCC3.3V pin in the target system interface connector always outputs a voltage of 3.3 V.
