Setting the DIP Switches
If you need to change any of the DIP switch settings, follow
these steps:
1. Locate the DIP switch block near the center of the system
board, shown on page 4-3. The switches are numbered
1 through 5, and the ON position is marked on the block.
2. Use a pointed instrument, such as the tip of a pen, to turn a
DIP switch on or off. The new setting takes effect the next
time you turn on the computer.
3. Depending on which DIP switch you change, you may also
need to run SETUP. For example, if you set DIP switch 4 to
ON to enable password security, you then need to enter
your password using
Set Password options
in SETUP.
See Chapter 2 for instructions.
Installing and Removing Options
4-9
