Others menu
Submenu
Function
SNMP
Set to
On
to monitor the projector using SNMP. To monitor the
projector, you need to install the SNMP manager program on
your computer. SNMP should be managed by a network
administrator. The default value is
Off
.
Trap IP Address
1/Trap IP Ad-
dress 2
You can register up to two IP addresses for the SNMP trap
notification destination.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from
0 to 255)
AMX Device Dis-
covery
When you want to allow the projector to be detected by AMX
Device Discovery, set this to
On
. Set this to
Off
if you are not
connected to an environment controlled by a controller from
AMX or AMX Device Discovery.
Submenu
Function
Crestron Room-
View
Set this to
On
only when monitoring or controlling the projector
over the network using Crestron RoomView
®
. Otherwise, set
this to
Off
.
Changes in projector settings take effect upon restarting.
When this is set to
On
, the following functions are not available.
•
Web control
•
Message Broadcasting (EasyMP Monitor plugin)
Bonjour
Set this to
On
when connecting to the network using Bonjour.
See Apple's Web site for more information on the Bonjour
service.
http://www.apple.com/
Message Broad-
casting
You can switch the EPSON Message Broadcasting function to
enable or disable.
You can download Message Broadcasting and its Operation
Guide from the following Web site.
http://www.epson.com
Network Setup
80
Summary of Contents for EB-G6800
Page 1: ...Installation Guide ...
Page 5: ...Main Guide ...
