Epson EB-1935, User Manual

Page: 79 / 157

Reading Error Notification Mail
When the Mail Notification function is set to On and a problem or warning
occurs in the projector, the following email will be sent.
Mail sender: Address for Address 1
Subject: EPSON Projector
Line 1: The projector name where the problem has occurred
Line 2: The IP address set for the projector where the problem has
occurred.
Line 3 and on: Details of the problem
The details of the problem are listed line by line. The main message
contents are listed below.
•
Internal error
•
Fan related error
•
Sensor error
•
Lamp timer failure
•
Lamp out
•
Internal temperature error
•
High-speed cooling in progress
•
Lamp replacement notification
•
No-signal
No Signal is input to the projector. Check the connection status or check
that the power for the signal source is turned on.
•
Auto Iris Error
•
Power Err. (Ballast)
See the following to deal with problems or warnings.
s
"Reading the Indicators" p.113
Management Using SNMP
By setting SNMP to On in the Configuration menu, notification messages
are sent to the specified computer when a problem or warning occurs. This
will enable the operator to be notified of problems with projectors even at
locations away from the projectors.
s
Network - Administrator Settings - SNMP p.105
a
•
SNMP should be managed by a network administrator or someone
who is familiar with the network.
•
To use the SNMP function to monitor the projector, you need to
install the SNMP manager program on your computer.
•
Up to two destination IP addresses can be saved.
ESC/VP21 Commands
You can control the projector from an external device using ESC/VP21.
Command list
When the power ON command is transmitted to the projector, the power
turns on and it enters warm-up mode. When the projector's power has
turned on, a colon ":" (3Ah) is returned.
When a command is input, the projector executes the command and
returns a ":", and then accepts the next command.
If the command being processed terminates abnormally, an error message is
output and a ":" is returned.
The main contents are listed below.
Monitoring and Controlling
79