From Installation to Projection
This section explains the procedure for connecting the projector to a
computer with the computer cable and projecting images.
ON
a
Connect the projector to an electrical outlet with the power cord.
b
Connect the projector to the computer with the computer cable.
c
Turn on the projector.
d
Open the A/V mute slide.
e
Turn on your computer.
f
Change the computer's screen output.
When using a laptop computer, you need to change the screen
output from the computer.
Hold down the Fn key (function key), and press the
b
key.
a
•
The method for changing differs depending on the computer
being used. See the documentation supplied with the
computer.
•
When turning off the projector, press the [
t
] button twice.
If the image is not projected, you can change the projected image using one
of the following methods.
•
Press the [Source Search] button on the control panel or the remote
control.
s
"Automatically Detect Input Signals and Change the Projected Image
•
Press the button for the target port on the remote control.
s
"Switching to the Target Image by Remote Control"
a
After projecting the image, adjust the image if necessary.
s
"Correcting Keystone Distortion"
s
Projecting Images
33
Summary of Contents for EB-1935
