Epson Apex, User Manual

Page: 6 / 158

FCC COMPLIANCE STATEMENT
FOR AMERICAN USERS
This equipment generates and uses radio frequency energy and if not
installed and used properly, that is, in strict accordance with the
manufacturer’s instructions, may cause interference to radio and television
reception. It has been type tested and found to comply with the limits for a
Class B computing device in accordance with the specifications in Subpart J
of Part 15 of FCC rules, which are designed to provide reasonable protection
against such interference in a residential installation. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause interference to radio and television reception, which
can be determined by turning the equipment off and on, you are encouraged
to try to correct the interference by one or more of the following measures:
l
Reorient the receiving antenna
l
Relocate the computer with respect to the receiver
l
Move the computer away from the receiver
l
Plug the computer into a different outlet so that the computer and
receiver are on different branch circuits.
If necessary, consult your dealer or an experienced radio/television
technician for additional suggestions. You may find the following booklet
prepared by the Federal Communications Commission helpful:
“Television interference Handbook”
This booklet is available from the U.S. Government Printing Office,
Washington DC 20402. Stock No. 004-000-00450-7
Note: If the interference stops, it was probably caused by the computer or
its peripheral devices. To further isolate the problem:
Disconnect the peripheral devices and their input/output cables one
at a time. If the interference stops, it is caused by either the
peripheral device or its I/O cable. These devices usually require
shielded l/O cables. For Epson peripheral devices, you can obtain
the proper shielded cable from your dealer. For non-Epson periph-
eral devices contact the manufacturer or dealer for assistance.
WARNING:
This equipment has been certified to comply with the limits for a Class B
computer device, pursuant to Subpart J of Part 15 of FCC Rules. Only
peripherals (computer input/output devices, terminals, printers, etc.)
certified to comply with the Class B limits may be attached to this
computer. Operation with non-certified peripherals is likely to result in
interference to radio and TV reception.
The connection of a non-shielded equipment interface cable to this
equipment will invalidate the FCC Certification of this device and may
cause interference levels that exceed the limits established by the FCC for
this equipment.
i i i