Options
•
Several lines of space occur in the printout.
Skip-over-perforation may be set. Set DIP switch 2-3 to
off.
• S k i p - o v e r - p e r f o r a t i o n i s s e t b u t d o e s n o t w o r k .
You may have changed the DIP switches with the power
on. To make new DIP switch settings effective, turn the
power off, then on again.
• S k i p - o v e r - p e r f o r a t i o n i s s e t , b u t t h e s k i p h a s s h i f t e d f r o m
the perforation, or the perforation does not fall in the center
of the skip.
The page length for one page of the continuous paper may
be set incorrectly. Set DIP switches 1-3 and 1-4, or use
control codes ESC C or ESC C 0 to set the correct page
length.
The loading position of the paper may be too high or too
low. Use the microadjustment feature to reset the loading
position.
•
W h e n p r i n t i n g e n d s , t h e p a p e r f e e d s a b r u p t l y , a n d a s i t
r e s u m e s p r i n t i n g , t h e p a p e r f e e d s b a c k w a r d a n d c o m e s o f f
the pull tractor sprockets.
You may have selected the short tear-off, which you cannot
use with the pull tractor. Be sure to set DIP switch 2-1 on.
•
When you press the
LOAD/EJECT
button to eject the paper,
the paper comes off the pull tractor sprockets.
When the paper release lever is in the continuous paper
position, the paper feeds backward to eject. When using the
pull tractor, press the
FORM FEED
button to feed the paper
forward.
Troubleshooting
6-13