O p t i o n s
•
The paper feed is crooked.
The paper may be old or creased. Use only new, clean
sheets of paper.
There may be too much paper in the stacker.
Make sure that the paper guides are set correctly and that
your paper is the proper size and quality.
l
O n e p a g e o f p r i n t i n g h a s s p r e a d t o t w o p a g e s .
Check that the page-length setting and lines-per-page
setting in your software are correct.
Switching between the cut-sheet feeder and the push tractor
does not work properly.
•
You
press the
LOAD/EJECT
button to load paper, but the
desired paper type does not load.
The paper release lever may not be in the proper position.
Pull the lever forward to load continuous paper or push the
lever back to load single sheets.
•
W h e n y o u c h a n g e t h e p a p e r - r e l e a s e l e v e r p o s i t i o n , t h e
p r i n t e r b e e p s c o n t i n u o u s l y .
You may have changed the paper-release lever position
while paper was in the paper path. Return the paper release
lever to its former position and press
LOAD/EJECT
button.
Then move the lever.
•
When you press the
LOAD/EJECT
button to eject continuous
paper, the paper jams or does not fully eject.
You may have tried to reverse feed too many pages. Before
ejecting the paper, always tear off the last printed page.
Never press the
LOAD/EJECT
button more than twice.
Troubleshooting
6 - 1 1