EPOX EP-6ZXM, Manual, Page: 49 / 76

BIOS
EP-6ZXM
Page 4-19
4-6 Load Setup Defaults
The “LOAD SETUP DEFAULTS” function loads the system default data directly
from ROM and initializes the associated hardware properly. This function will be
necessary only when the system CMOS data is corrupted.
4-7 Integrated Peripherals
Figure 8: Integrated Peripherals
Note: If you do not use the Onboard IDE connector, then you will need to
set Onboard Primary PCI IDE: Disabled and Onboard Secondary
PCI IDE: Disabled
Note: The Onboard PCI IDE cable should be equal to or less than 18
inches (45 cm.).
IDE HDD Block Mode: IDE Block Mode allows the controller to access blocks
of sectors rather than a single sector at a time. The default is Enabled.
Enabled: Enabled IDE HDD Block Mode. Provides higher HDD transfer rates.
Disabled: Disable IDE HDD Block Mode.
Esc : Quit : Select Item
F1 : Help PU/PD/+/- : Modify
F5 : Old Values (Shift) F2 : Color
F7 : Load Setup Defaults
ROM PCI/ISA BIOS(2A69KPAB)
INTEGRATED PERIPHERALS
AWARD SOFTWARE, INC.
IDE HDD Block Mode : Enabled
IDE Primary Master PIO : Auto
IDE Primary Slave PIO : Auto
IDE Secondary Master PIO : Auto
IDE Secondary Slave PIO : Auto
IDE Primary Master UDMA : Auto
IDE Primary Slave UDMA : Auto
IDE Secondary Master UDMA : Auto
IDE Secondary Slave UDMA : Auto
Onboard Primary PCI IDE : Enabled
Onboard Secondary PCI IDE : Enabled
USB Keyboard Support : Disabled
Init Display First : PCI Slot
POWER ON Function : Hot Key
KB Power ON Password : Enter
Hot Key Power ON : Ctrl-F1
KBC Input Clock : 12MHz
Onboard FDD Controller : Enabled
Onboard Serial Port 1 : 3F8/IRQ4
é é é é é ê
ê ê ê ê è è è è è ç ç ç ç ç
Onboard Serial Port 2 : 2F8/IRQ3
UART Mode Select : Normal
RxD, TxD Active : Hi, Lo
IR Transmitting delay : Enabled
Onboard Parallel Port : 378/IRQ7
Onboard Parallel Mode : ECP / EPP
ECP Mode Use DMA : 3
EPP Mode Select : EPP1.7