epiphan KVM2Ethernet, User Manual

Page: 37 / 188

3. Windows VGA2Ethernet user interface Starting the VGA2Ethernet user interface
User Guide Page 37
• Capture device not found as the VGA2Ethernet user interface
attempts to connect with VGA2Ethernet or KVM2Ethernet
devices on your network.
This message only displays for a few seconds unless the
VGA2Ethernet user interface cannot find any devices or if all
of the devices have a viewer password. To connect to a device
with a viewer password, select Select Device or Connect
Network Device from the Capture menu and when prompted
enter the device’s viewer password. For more information, see
“Adding or Changing the Viewer’s Password” on page 108
and “Capture Menu” on page 47 .
• Detecting Video Mode as the VGA2Ethernet user interface
connects to a device and then determines the video mode of
the device.
• Tuning Capture Parameters as the VGA2Ethernet user
interface synchronizes and tunes capture settings and image
adjustments (see “Configuring Image Adjustments” on
page 115 for more information).
• No Signal Detected if the VGA2Ethernet user interface
connects with a VGA2Ethernet or KVM2Ethernet device that
is not connected to an active video source.
If the VGA2Ethernet user interface successfully connects to and
synchronizes with the VGA2Ethernet or KVM2Ethernet device, it
begins displaying captured images. Figure 20 shows the user
interface connected to a VGA2Ethernet device at IP address
192.168.20.21.