Quadro Manual I: Installation Guide
Appendix: Configuring NAT Traversal
Quadro2x, 2xi; Quadro4x, 4xi; Quadro16x, 16xi (SW Version 5.3.x)
53
Fig. I-42: NAT Traversal Settings – General Setting
Go to
SIP Parameters
page.
Fig. I-43: NAT Traversal Settings - SIP Parameters
Select
Use Manual NAT Traversal
and enter the WAN IP address of the router into the
Mapped Host
text field. For
Mapped Port
, enter the router's corresponding port num-
ber, in this case
5060
.
Save
the entries.
•
Go to the
RTP Parameters
page and select
Use Manual NAT Traversal
.
Fig. I-44: NAT Traversal Settings - RTP Parameters
•
Enter the WAN IP address of the router into the
Mapped Host
text field. Set the
Mapped RTP/RTCP Port Range
according to the values specified on the router, in this
case to
6000 (Min)
and
6099 (Max),
respectively. Click the
Save
button to save the
contents.
The Quadro will activate the settings and register the extensions on the Epygi SIP Server
after a few minutes. You can verify the settings from the main
Quadro Management
menu
under
Status
in the
SIP Registration
Status
section.
