Epever SolarV TRIRON Series, User Manual

Page: 41 / 59

Copyright© 2022 SolarV GmbH All rights reserved.
37
parameters should be x2 for LFP8S.
x
When the battery type is "USE," the Lithium battery voltage parameters follow the
following logic:
A. Over Voltage Disconnect Voltage>Over Charging Protection Voltage(Protection Circuit
Modules(BMS))+0.2V;
B. Over Voltage Disconnect Voltage>Over Voltage Reconnect Voltage
˙
&KDUJLQJ/LPLW9ROWDJH•
Equalize Charging Voltage
˙
%RRVW &KDUJLQJ 9ROWDJH • )ORDW &KDUJLQJ 9ROWDJH!%RRVW
Reconnect Charging Voltage;
C. /RZ 9ROWDJH 5HFRQQHFW 9ROWDJH ! /RZ 9ROWDJH 'LVFRQQHFW 9ROWDJH • 'LVFKDUJ ing Limit
Voltage.
D. 8QGHU 9ROWDJH :DUQLQJ 5HFRQQHFW 9ROWDJH!8QGHU 9ROWDJH :DUQLQJ 9ROWDJH• 'LVFKDUJLQJ
Limit Voltage;
E. Boost Reconnect Charging voltage> Low Voltage Reconnect Voltage;
F. /RZ9ROWDJH'LVFRQQHFW9ROWDJH•2YHU'LVFKDUJLQJ3URWHFWLRQ9ROWDJH%06 +0.2V
WARNING
The required accuracy of BMS is no higher than 0.2V. We will not assume
responsibility for the abnormal when the accuracy of BMS is higher than 0.2 v.
5.2 Load working modes
5.2.1 LCD setting
1 ˅ ˅ DS1 module display and operation
Operation:
Step1: Press the button to switch to the load type interface.
Step2: Long-press the button until the load type interface flashes.
Step2: Press the button to select the load type.
Step3: Press the button to confirm.
2 ˅ ˅ DS2 module display and operation