REV. 12/2020
21
B
2.3.10
Operating the truck without its own drive system
If the truck has to be moved after a failure
has rendered it immobile, proceed as
follows:
Set the emergency stop switch “OFF”.
Set the key switch “OFF” and remove the
key.
Prevent the truck from rolling away.
Lift the vehicle carefully with lifting
equipment.
Screw in two screws(1)
, M4*35mm until the
truck can be moved (no braking action).
After setting down the truck at the
destination, un
screw two screws(1)
.
Braking action is restored!
This operating mode is not permitted when
negotiating inclines and gradients.
WARNING
2.3.11
Transporting the truck
When transporting the truck, check that it is
properly supported on wooden blocks and
correctly tied with rope.
Fold the side protection bars and foldable
platform so they do not protrude from the
vehicle body.
CAUTION
Tie points and position
Lower the fork arms to the lowest position.
Use wooden chocks (1) to secure the front
and rear of the vehicle.
Pass the tensioner through the inner and
outer masts and secure the masts to the
upper fixing points of the vehicle, as indicated
by position (2) in the figure.
Tighten by pulling in the direction of the
arrow.
DANGER
After setting down the truck at the destination,
un
screw two screws(1)
.
Braking action is restored.
