EP Equipment JX0-30, Operation Manual

Page: 70 / 74

REV. 08/2019
5 I
Charging
This battery can only be charged with the vehicle-specific charger, other chargers may
cause battery damage.
The normal charging temperature range of the battery is: 5°C ~ 40°C, please do not charge
in the environment beyond the normal temperature range;
If the battery is not fully charged in specified time, check the max. voltage of the cells of the
battery, if it is higher than 3.65V, stop charging it immediately, and contact the after-sales
service.
During the charging operation, it is necessary to have professional personnel to operate
and care, in order to ensure that the charging plug and socket work normally without heat,
to ensure that the charging device works normally, to ensure that the battery pack and its
protection circuit work normally, and the whole power supply system has no sign of short
circuit, over current, over temperature or overcharge.
When charging, connect the battery to the charger; after starting charging, the circular
display meter will display the total voltage, the maximum and minimum cell voltages,
power, temperature, charging current and other information; pay particular attention to
the charging current and the maximum and minimum cell voltages, as well as the voltage
difference between them; if there is abnormality, stop charging in time and contact the
after-sales service department for solutions.
1.1.3
Identification
•
•
•
•
•
W A R N I N G
No hot plugging Beware of corrosion No stepping no surface No fireworks Must wear protective gloves
Rainy Day Driving
When the water depth of the road area is less than 30cm, and the vehicle should pass the wading section at a uniform
speed of 5km/h to 10km/h; when the water depth of the road area is more than 500mm, it is strictly forbidden to pass.
Vehicle Water Immersion
When the vehicle is parked to a water depth of not less than 50cm, it is strictly forbidden to start the vehicle;
the water-immersed vehicle must be removed from the flooded area at the first time, the MSD and low-voltage power
supply manual switch must be disconnected; at the same time, all high and low voltage harnesses connected to the
battery and the power supply must be disconnected; immediately contact the after-sales personnel for on-site
investigation to eliminate potential safety hazards.
Vehicle Repair
High-voltage danger can cause serious injury or even be life-threatening! Users are not allowed to disassemble any
parts or repair!