EOS Moment W, Assembly And Operating Instruction

Page: 36 / 56

36
EN
Therefore, should the RCD be released dur-
ing heat-up, the electrical installation must be
checked.
Installation of the sauna heater and control
unit must be undertaken only by an author-
ized electrician. Without a documented proof
of such installation a warranty is generally void.
Special advice
By installation of sauna heaters, please pay at-
tention to the DIN VDE 0100 part 703 or similar
locally applicable national safety regulations !
The DIN standard makes the following state-
ment valid in your newest expenditure, since
February 2006, paragraph 703.412.05; Quota-
tion:
The additional must be planned for all electric
circuits of the Sauna by one or more fault cur-
rent protection device (RCDs) with a calculation
difference stream not more largely than 30 mA,
excluded of it is Sauna heating.
The EN 60335-1 DIN (VDE 0700 part 1):2012-10
states the following in paragraph 13.2; quote:
The leakage current may not exceed the follow-
ing values during operation:
- for stationary heaters of protection class I 0,75
mA; or 0,75 mA each kW input of the appliance,
depending on the higher value, at a maximum
value of 5 mA.
If the appliance is equipped with a protective
device for leakage current (RCD), please pay at-
tention to the fact that no other electrical units
will be protected by this RCD.
Under current manufacturing technology, it is
not reasonable to use heating elements for sau-
na heaters which do not collect moisture from
the surrounding air. It is therefore possible that
a little bit of moisture from the surrounding air
may reach the magnesium-oxide filling in the
heating elements during transport or storage
and may cause the RCD to release.
In this case the oven must be heated up under
supervision of an expert, during which the PE
conductor is not connected. After about 10
minutes, when moisture has evaporated from
the heating elements, the oven must be recon-
nected to the PE conductor!
If the sauna heater is not in use for a significant
period of time, we recommend running it every
6 weeks, so as to avoid moisture concentrating
in the heating elements.