EOS Moment W, Assembly And Operating Instruction

Page: 25 / 56

25
EN
•
When designing the cabin ensure
that the external exposed glass surfaces
only reach a maximum temperature of
76°C. If necessary, protective features
need to be fitted.
•
Please note that the wooden surfaces in
the areas exposed to high heat are subject
to possible discolourations (e.g. darkening
of wood).
Electrical connection
Using the above-mentioned wiring diagram
and the information on the wiring circuit ad-
hered to the respective control system, your
electrician will be able to connect the system
without further instructions.
Please note that, for safety reasons, power ca-
bles may not be laid visibly on the interior walls
of the cabin. Most sauna cabins have empty
ducts fitted into the wall element with the air
intake.
If no empty ducts are available in your cabin,
drill a sufficiently sized hole in the cabin wall
directly next to the place where the cable exits
the sauna heater and guide this cable outside
through the hole to the control unit. The cable,
and all other connecting cables (mains power
cables and cabin lighting), should be installed
in installation ducts or also be protected against
damage on the outside of the cabin e.g. by lay-
ing them in installation pipes or attaching wood
cover strips.
Caution!
Dear Customer,
In compliance with the valid regulations,
only certified electricians may connect the
sauna heater and the sauna control system
to the mains power supply.
Please note that you must provide a copy
of the invoice from the electrical company
who installed the sauna in case of a war-
ranty claim.
To preserve the right of a warranty claim,
only original spare parts of the manufac-
turer may be used.