8
3. Operation
The control unit is intended for two
operational modes:
- Dry (Finnish) sauna
- Steam sauna
In the dry (Finnish) sauna mode the sauna
air is not steamed additionally. The sauna
air temperature can be set up to 110°C.
During steam operation the maximum
temperature is limited to 65°C for safety
reasons.
The configuration of the operation
elements are shown in Illust. 12.
À
Switch knob to select the following
functions
Heating
= sauna oven on
Light/heating
= sauna oven +
cabin lighting on
Fan/light/heating
= sauna
oven + cabin li fan on
Fan = fan (if installed) on
Licht = light is on
0 = all installed components are off
Á
Turning dial for temperature selection
Â
Button for increasing steam level
Ã
Button for decreasing steam level
Ä
Button for CLIMA - mode
Å
LED-display for steam level
Æ
Standby display
Ç
Operation display for sauna oven
3.1 Startup of dry (Finnish) sauna
operation
Switch the sauna oven with the left hand
dial to
À
operation, i.e. one of the switch
positions with the symbol.
The green LED above the button will light
up. Depending on the current temperature
in the sauna cabin, the sauna oven's red
operational display
Å
will light up, signaling
the oven is heating.
Use the right hand dial
Á
to set the desired
cabin temperature. For a higher
temperature turn the knob clockwise, for a
lower temperature counter-clockwise.
The temperature can be set from 70°C up
to 110°C (during sauna operation). Please
take into consideration that these values
can vary by a few degrees, depending on
cabin configuration. For safety reasons the
temperature is measured in the hottest
area of the cabin above the oven. This
temperature serves as a value for the
temperature around the sauna benches.
Depending on oven capacity and
placement of the fresh air vents,
undesirable influences can alter these
measurements, not allowing the maximum
temperature to be reached. The control
range is laid out so that normal
temperatures from 90 to 95°C in the bench
area can be preselected.
3.2 Steam operation
A suitable vaporizer unit up to 3 kW and
230 V AC is required for steam operation.
The control unit "clocks" the vaporizer
based on the user-set steam level. Use
the three buttons below the digital display
Å
to set the vaporizer performance level.
0
english
