16
Call 1300 369 273
www.enware.com.au
The ENWARE AQUABLEND SQX Thermostatic Mixers are
supplied factory set at a maximum of 41ºC +/- 2ºC. To
alter this temperature adopt the following procedure:
Note: Changing the maximum set temperature will
change the amount of rotation of the handle. Increasing
the temperature will mean extra rotation, while
decreasing the temperature will result in less rotation.
1 Ensure the mixer is in the ‘OFF’ position (refer to
IMAGE
32-34
on page 15). Using a 3mm Allen Key, remove the
Handle locking pin and lift the handle vertically off the
mixer Cartridge (refer to
IMAGES 35 and 36
).
2 With the top of the mixer and cartridge now exposed,
remove the upper temperature ring away from the
cartridge spline
IMAGE 37
- take care not to remove
the lower temperature ring. Loosely re-fit the handle
in this ‘OFF’ position
IMAGE 38
3 Turn the tap on and check the temperature of the
water with a hand held digital thermometer. With
the thermometer gauge held within the flow stream,
continue to move the handle until the desired
(Maximum) temperature is achieved.
4 Once desired temperature is achieved, remove handle
without changing spindle position. Re-fit the upper
Temperature cam so the lug can form a stop against
the brass shoulder on the cartridge -
IMAGE 39
.
5 Loosely re-fit handle and turn to ‘OFF’ position. Re-fit
handle in its correct ‘off ‘ position orientation as seen
in
IMAGE 20
on page 12.
6 Secure Handle again using the handle locking pin and
3mm Allen Key -
IMAGE 40
IMAGE 36
IMAGE 38
IMAGE 40
IMAGE 35
IMAGE 37
IMAGE 39
temperature adjustment
Summary of Contents for AQUABLEND SQX ATM606
Page 28: ......
