2. After the installation, the unit must be checked
for sealing, both for air and light leakage. Any
leaks to the Air Cleaner must be sealed with
aluminum tape.
3.
Turn the Air Cleaner ON and check for any
leaks of light. There must be no visible blue light
from the Air Cleaner. If you see any blue light
from the duct connections cover the holes with
aluminum tape.
OPERATING INSTRUCTIONS
The Air Cleaner is designed to run continuously to
provide clean, filtered air 24 hours a day. The fan
on the heating/cooling system, to which the Air
Cleaner is dependent on for circulated air, should
be on ‘continuous’ setting.
Running the Air Cleaner intermittently will
shorten the effective life of the lamps.
The Air Cleaner plugs into a regular 120 volt outlet
and is controlled by a switch located on the side of
the unit, near the cord.
Note: Do not allow the cord to be placed where
it may be walked on or allow anything to roll over it.
MAINTENANCE
For efficient operation, the filters must be changed
on a regular basis. If you notice a reduction in air
flow from the system, check the filters.
Replacing the HEPA Filter and Prefilter
1. To access the filters, turn the Air Cleaner
OFF
at
the switch and open the top front door.
2. Carefully remove the filters to avoid spilling of
collected contaminants. Dispose of filters in a
plastic bag and discard with regular household
trash.
3. Remove the plastic from the new filters before
installing. Discard plastic safely. Take care not to
damage the filters. Hold by the filter frame only.
4. Date the replacement filter in the space provided.
5. Place the filters in their appropriate track with the
arrows pointing toward the fan.
WARNING
Never use the Air Cleaner without all of the filters in
place and all cover panels and doors closed. Make
sure all the screws are in place.
CAUTION
Make sure to turn the Air Cleaner
OFF
before
performing any maintenance or removing any filters.
5
CAUTION
When the unit is new or after the lamps have been
replaced there may be a temporary odor. An odor may
also occur with high concentrations of chemicals in the
home such as paint or strong cleaning solutions. Both
odors are temporary and should dissipate within a
short time.
WARNING
Eye and skin damage may result from direct exposure
to the light produced by the lamps used in this product.
Make sure the Air Cleaner is
OFF
and
UNPLUGGED
before the lamp access panel is open.
CAUTION
Do not touch the lamp glass with bare hands. Always
use the gloves provided when installing the lamps. The
oil from your hands may reduce the effectiveness of
the lamp. The lamp may be cleaned with a soft cloth
dampened with water to remove finger prints.
Fig. 4 – Self-Contained Attic Installation
Prefilter
HEPA Filter
Filter Access
Door
UVC Lamps
PCO Filter
Final Filter
Lamp Access
Removable
Panel
Fig. 5 – Air Cleaner Layout
1
2
3
4
